Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create customised NX drawings templates/borders?

Often Asked, General

How to create customised NX drawings templates/borders?

by  Arkance/PhoeNX  Posted    (Edited  )
We have created a series of videos about creating borders and templates in NX.
http://vimeo.com/album/3065578 is the album on Vimeo.

The videos have been created with NX9.
Auto Borders and Titleblocks are from NX8 and up.
Everything else demonstrated should apply for NX5 and onwards.

Anthony Galante
Senior Support Engineer

[IMG http://i1306.photobucket.com/albums/s580/namdaci/signature_videoCenter_zps09c916dc.jpg]





Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top Bottom