Recent content by Abbarth

Finally it worked but with a tolerance of 0.05 mm. Thank you for your support

I do the check this way, I just make a section through my sewed suraface. if I see the empty space between the two walls, then It's not a solid. if yes, then its a solid. The funny way is that I convert my enclosed surface to step file and open it again, I extracted all faces again and sew it...

Thank you for the answers. I still got a question regarding sewing operation while creating a solid body. If with the sew command having tolerance of 0.001 mm there are small gaps in my surface and with a tolerance of 0.010 mm the operation see no gaps, shall the sew operation convert the...

Hello, I ve got some trouble generating the surfaces that I uploaded here(see attachement). The surfaces are step file, I wanted to re-create them as NX Features(not extract face or synchronous modelling) and I get stuck by not knowing how to proceed. First of all I tried to sweep, curve...

I solve the problem :) sorry for posting it. It works like this: Right click on the view - Settings - Angle and then set your desired angle.

Is it possible to rotate a view in drafting application? e.g. My bottom view is not oriented exactly as I want, my wish is to rotate it at 90 degrees in order to save some space(the same view but different direction). Is there any options do rotate it or I shall rethink it in the 3D mode? Thank...

After reading a lot of posts regarding this issue, I still don't get it how to generate a solid from a surface. I will explain my steps(It's about NX 10): 1 Import the Step data 2 Heal geometry 3 Reopen the healed geoemtry and extract surfaces 4 Sew with tight tolerance (0.001) - no problem in...

Hello kapmnit123, do you think that adding additional cross section will improve the surface? Or I shall be using other feature instead swept? Thank you!

Later edit. Is there any possibility to improve the Blend radius in the problematic area? Can it be adjusted in order to have a "flowing" edge bend? This kind of Edge Blend will not let me afterwards to Shell the part if I add additional feature to the part. Thanks a lot.

First of all thank you for your quick reply. The cut problem was managed but when I'm trying to blend the edges of the surfaces with a 3 mm blend radius - it's not working as I was expecting. Could you please suggest how to create additional 3 mm blend radius(please see attached file). Thank...

Hello everybody, can any one help me to "cut" the part which I attached with the Swept/Trim and extend funtions. Every time when I'm performing the cut the system will notice that the tool and target do not form a complete intersection. After swept Operation I tried to enlarge the surfaces to...

Thank you for your replies.

@cowski which are those synchronous commands to modify the imported geometry? @Frank2288 yes, NX

thread561-362063 Hello everyone, I have a complex STEP file which shall be converted to a "living geometry" using NX. The NX Exctract Geometry Feature makes a great job, but the problem remains with the surfaces which cannot be modified. Is there any way/work steps for converting imported...