Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Adrian99

  1. Adrian99

    SET n command

    I have used the SET card to control which nodes/elements to print/plot results for by defining the card in the "Case Control Section". However I have been caught out in the past by forgetting the maximum line length in this section is 72 charachters.
  2. Adrian99

    Patran crashes caused by PCL using too much memory

    Hello All, I'm currently writing a routine in PCL to aid in the generation of simple meshes (a pipe/bracket installation). The routine works fine if only a small mesh is asked of it (a pipe with two bends and 5 brackets say). However, when a larger mesh is required (several pipes and 20...
See more

Part and Inventory Search

Back
Top Bottom