Hello everyone. I have a question regarding CSA B149.1.
In section 5.1.1, it states that any natural gas line entering an industrial building cannot exceed 66 psig. Is this applicable to FG lines entering all package buildings in a processing facility (for fuel purposes)? As I've seen a lot of...
Hello everyone.
If you have a hot oil (petrotherm for example) closed system with a direct fired heater heating a few end users, such as a condensate stabilizer for example. Is there a best practice in terms of the hot oil operating pressure being higher or lower than that of the end user...
Hello everyone. I have been discussing a lot with different vendors and very experienced process engineers on hot oil systems. There is a lot of different opinions on whether or not hot oil should be normally flowing through the expansion tank.
Some propose that flowing through the expansion...
Hello everyone,
I was trying to find if there is a specification or standard that specifies the minimum stack height above the building for a direct fired heater.
The most I found was 2 things:
1- CSA specifying that the minimum requirement is 1.2 * building peak height. However, this is for...
Hello everyone,
I was trying to find if there is a specification or standard that specifies the minimum stack height above the building for a direct fired heater.
The most I found was 2 things:
1- CSA specifying that the minimum requirement is 1.2 * building peak height. However, this is for...
Hello everyone,
I was trying to find if there is a specification or standard that specifies the minimum stack height above the building for a direct fired heater.
The most I found was 2 things:
1- CSA specifying that the minimum requirement is 1.2 * building peak height. However, this is for...