Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by AliGokce

  1. AliGokce

    Can't get path stresses??

    So it seems when SUMTYPE,PRIN is used, you can't get path stresses or section stresses from load cases.
  2. AliGokce

    Can't get path stresses??

    Hello, I am using Ansys for mechanical analysis. When I read in an RST file and use SET command, I can get stresses along a path. But when I assign the results to an load case ID using LCDEF, I get 0 stresses along the path. Any idea what I am missing? -Al
  3. AliGokce

    Cyclic symmetry setup in NX Nastran

    Hello, I setup a rotational cyclic symmetry modal analysis run in NX nastran following the guidelines in the user manual. I can't make sense of the results. In F06 file, it gives a separate eigenvalue block for each harmonics starting from 0. I was hoping that Nastran would assemble solutions...
See more

Part and Inventory Search

Back
Top Bottom