Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Ameen11

  1. Ameen11

    High Performance Ball Valve

    Client is requesting ball valve for scrapper kicker line to be high performance. can someone help me understand what makes a valve high performance and why is it needed for this application?
  2. Ameen11

    Is it allowed to have Pig trap with different wall thickness than Pipeline

    Hello 1503-44, Thanks for your response. i saw in B31.8 the limitation on end preparation butt welding but i was not sure if this was applicable. i will make sure check hoop stress of the taper if this the route i go for.
  3. Ameen11

    Is it allowed to have Pig trap with different wall thickness than Pipeline

    Thanks LitteInch, I think tapering the end would be the best option. I will have to check on why it has a different CA.
  4. Ameen11

    Is it allowed to have Pig trap with different wall thickness than Pipeline

    Dear All, I am in the process of designing a pig trap using ASME B31.8. However, the trap is being designed with C.A. (Corrosion allowance) of 3.2 mm and the pipeline has 0 C.A. I am not able to find any guideline for designing traps in 31.8 is there an issue of having different ID between...
See more

Part and Inventory Search

Back
Top Bottom