Thank you for the information. Yeah I intend to do that because I have a rotating component in the middle, So need to know the weight of the lower portion/ rest when the positions are changed. Kind of difficult to explain.
Regards,
Paul
Hi All,
i have an assembly, I want to measure weight from the end to the middle (and not the full or individual part). Please help how can measure weight up to certain length (measurement taken from corner).
Think of an assembled box, and I need to measure the weight from the corner to the...
Hi,
The stackup is to be done at an initial stage i.e there would be no movement (of the plunger rod) at all. And there is no load as well. What I want is to create a stack path and calculate thereafter, but the problem is 2.18 and 2.58 is overlapping. So in this case how do I approach for...
Hi,
I am trying to figure out the gap between the end of (1) and the portion of (6) which is outside, and it would finally help me to get the overall length (OAL) (which is what I am calculating by worstcase and later RSS). The problem I am actually facing here is, the dimensions 2.18 and 2.58...
Hi,
Please find the attachment of the aprt. I am really struggling to perform stackup on this. Please help
Regards,
Paulhttp://files.engineering.com/getfile.aspx?folder=d815ed7c-eec3-48e1-a703-708172f1ef8e&file=tolrnc_help.JPG
Hi capnhook,
Yes it is expected to be well versed and that is the reason for my thread. I lost my practice since I am involved in concept design stuffs. And to add, time limit what they give for a complex part is very short. The university books has some basic drawings, what I was expecting...
Hi,
I am attending an interview for Design Lead. There is a round for tool test in Nx
Can someone please post some intermediate to complex CAD drawings for practice (part, surface,sheet). Or any link or book where I can practice the drawings to crack the tool test easily. Seeking help and...
Hi Kenat,
Thanks for your reply. I am specifically looking for the application of process capability and CPk and based on what are they applied. I understand till RSS but after that I don't understand why they use sigma values i.e rss multiplied by 6sigma/3sigma.
Regards,
Amit Paul
Hi,
I want to have a good understanding on Statistical tolerances and the sigma consideration. Can any one refer me a good link for a website? Thanks in advance
Regards,
Amit Paul
Appreciate all the replies. Many Thanks.
I have a very little experience in Visual Basic, is that fine to start with? or Do I start learning C++? What I am trying to say is which language should I have a good hold on to get started with NX automation. Thanks in advance.
Regards,
Amit Paul
