Thanks George. I'm OK if the error is consistent. It means our flow reading will be out but as long as there is enough oxygen in the off-gas we can work with it. I think I'll push for a change - I'd rather have an accurate reading I can use in a heat and mass balance later on.
Thanks danw2. I don't know what he thinks he is saving - it is probably less than 1m of impulse tubing, though at this stage of the project it is also some engineering & drawing changes, still no big deal. There's also a very short inlet duct length, so I'm pretty sure the flow will not be...
Hi.
I am reviewing a vendor's design for a burner air supply which uses a venturi flowmeter to measure the combustion air flowing into the combustion air fan. The flow will be around 15,000 m³/h. So the air flow will be from atmosphere, through an inlet silencer, through the venturi and into the...
