The example I have heard of is a logo. You may want it's form controlled more tightly than it's location/size/orientation. I would welcome others to join in if they have seen other good candidates for the recommended use of it. I am exploring it's true practicality.
Yes, I was assuming that they would take as many points as are needed. However, my question was more practically speaking, are there routines written in inspection software that handle this already? Seems like this would not necessarily be easy as a profile tolerance zone can take some very...
To all my fellow GD&T enthusiasts out there... I'm curious, how are you inspecting dynamic profile from the ASME Y14.5-2018 standard if you are using it?
Example: How would you inspect, practically Fig 11-20, in the new standard? Assuming this is a CMM routine?
