Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Biggun

  1. Biggun

    Fabricated 4way cross section

    This raises something I've always wondered about: could you split 2 tees down the centerline of the run, then bevel the two pieces and make a cross by welding together the 2 pieces with the branches? Same question with 2 - 45's to make a symmetrical Y?

Part and Inventory Search