Hi All,
AS mentioned in above subject I have an query. I have described briefly as below.
As per PG-29.7 (compensation on Semi-Ellipsoidal Dished Head) "If a flanged-in manhole that meets the code requirement is placed in ellipsoidal head, the thickness of head shall be same as for head dished...
Dear All,
With reference to the above subject I would like to raise my query.
I have one stiffener attached to the shell portion which is very near to the shell-cone juncture, i.e. approx. 10mm. Here should I do any NDE procedure for the cone to shell juncture ?
As I understand that...
Dear MK Shah,
The ultimate solution would be come out if you consult with your client. Further more the least way out is if you change your joint efficieny. I think probably you are considering the joint efficiency as 0.85. So you can change that to 1 , As a result you will definetly meet your...
MAulik,
For clear your view in real condition your top section pressure is always less than the bottom. Bottom section pressure is always higher due to my liquid level.
Further more i think you have certain pressure drop in your column.i.e. Overall pressure drop of column mentioned in our MDS...
Dear Mr. Tom Barsh,
I am not agree & confuse to your response. As it is a multi pressure chamber (Top Sec-8.2kg/cm2 & Bttm Sec-8.9 Kg/cm2) & there no pressure boundaries between the two sections it is considered as a single Chamber. As a result the calculated MAWP shall be the lowest/governing...
