Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Burunduk's latest activity

  • Burunduk
    Burunduk replied to the thread Unilateral tolerances-why?.
    Sometimes unilateral tolerances just "feel" right. The faces of the support bosses in this cover can be fully coplanar with a plane...
    • 1000017122.jpg
    • 1000017121.jpg
  • Burunduk
    Burunduk replied to the thread General note for a new titleblock.
    ISO 2768-mK is a reference for both untoleranced dimensions according to ISO 2768-1 (m class) and unspecified geometric tolerances...
  • Burunduk
    Burunduk replied to the thread Multiple tolerances on a hole.
    mhorbacz, The suggestion I showed you follows how similar control is achieved per ASME Y14.5. To tell you the truth, had I looked at...
Show older items

Part and Inventory Search

Back
Top Bottom