Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by CanadianRebel

  1. CanadianRebel

    Low pressure cut off valve question

    Thank you for your replies. There are no hydrants downstream. I should have described the scenario better in my original post, but I was trying not to confuse my question with a look at the entire project. I really just want to know if there is such a valve that closes with low pressure...
  2. CanadianRebel

    Low pressure cut off valve question

    Thanks for the response! So the pipe is basically a service line feeding water from the City water main to a community water system that has wells that are drying up. It spans across a slough into a pump house storage tank that would then feed into a treatment facility to offset the loss of...
  3. CanadianRebel

    Low pressure cut off valve question

    Hello I am a new EIT and have a question about pressure valves. To summarize the scenario: A waterline was installed at the bottom of a slough (anchored to the ground; not covered). Because this waterline could potentially be damaged, we want to install a valve that would close if the...

Part and Inventory Search