Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by carguy333

  1. carguy333

    Filled Sketches Shown In Drawing

    Hello dgallup, Thanks for replying. In the time between my post and your reply I did figure out (with help from others) how to "fill" the sketch in the drawing, but I had to do it a different way then you describe. For anyone who stumbles upon this thread looking for a solution, one way to...
  2. carguy333

    Filled Sketches Shown In Drawing

    Hello all, I need help with something I am trying to do in my drawing. I am using Creo 6.0. Let me start by describing what I am trying to achieve. I have an anodized sheet of aluminum that gets cut and then has an engraving operation done in the middle of the part to show a patterned...

Part and Inventory Search