Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by cycleback

  1. cycleback

    Source for stock aluminum tubing with 10" ID with a tight tolerance/finish on the ID?

    Any suggestions where to source aluminum pipe 10" nominal schedule 60, 80, E.H./X.H., or 140?
  2. cycleback

    Source for stock aluminum tubing with 10" ID with a tight tolerance/finish on the ID?

    The alloy doesn't need to be 6061-T it was merely convenient. Probably a total of 3 to 5 parts of this tubing will be made.
  3. cycleback

    Source for stock aluminum tubing with 10" ID with a tight tolerance/finish on the ID?

    I have looked at pipe but haven't found aluminum in that ID size. Always much smaller IDs. Any recommendations on suppliers for pipe that would likely have something in 10" ID?
  4. cycleback

    Source for stock aluminum tubing with 10" ID with a tight tolerance/finish on the ID?

    Does anyone know a source for aluminum tubing with a 10" ID that has a tight tolerance on the ID in its stock purchased condition? I need something with a 0.5" or 1" wall thickness and ~10" length. Ideally the ID surface would be honed or have a nice finish. Maybe something used as a hydraulic...
  5. cycleback

    Advice for Compression Die Design

    I would appreciate some feedback on a compression die design that I am leading. My background is electrical engineering and I have never designed a die before. This is in an academic environment so there is little practical experience with this sort of thing. I have met with a tool and die maker...
See more

Part and Inventory Search

Back
Top Bottom