Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by dhweizel

  1. dhweizel

    turn on yaskawa psu

    I'm retrofitting a hyundai drill tap center, originally it use a yasnac mx3 with some problems and I'm installing a new computer running linuxcnc. I planning to reuse the 24v psu to avoid the need to run new cables and connectors to the io. regards
  2. dhweizel

    turn on yaskawa psu

    Success!!! the missing bit of info that there is three pins to power on was the key. For the posterity: in the corner of the connector (from the back) there is a gnd pin surrounded by pins with pull up resistors to 24v . To power on the psu you must short to gnd in this way : The...
  3. dhweizel

    turn on yaskawa psu

    Thanks for your reply itsmoked, the fact that there is no watchdog or something more complicated is a great news.
  4. dhweizel

    turn on yaskawa psu

    Hi, I have a question for itsmoked but any help will be apreciated. I'm looking for a way to use a cps-10n psu from an old yaskawa cnc controller but without the cpu. The psu works and the source led lights up but I can't power up the main outputs . I think that the on signal is in the bus like...
See more

Part and Inventory Search

Back
Top Bottom