Hello all,
I'm currently design a BES type heat exchanger in PVElite with ID of 800 mm and 23 bars design pressure at shell and tube side at 240 deg C and I am not sure on how to design the floating head part. I have listed my queries in below points.
1. Should the ID of channel part of...
Hello,
I would like to know the important design consideration that I should keep in mind for BEM type exchangers while designing in accordance with ASME Sec VIII Div1 using PVElite software.
Would appreciate the insightful information.
Regards,
Dinesh
Dear Professionals,
Can anyone suggest me methods to pass the saddle in unity check, Which parameters effects this ratio in saddle design. Thanks for your response in advance.
Regards,
Dinesh
