Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Doogan

  1. Doogan

    Title Block Tolerances

    Thanks everybody for your fast responses! I will push back in favor of the .010 for my application. Eric
  2. Doogan

    Title Block Tolerances

    What are some of the more common Title Block Tolerances used for inch units? Is there any basis (standards) for these values? My experience has been that a .XXX (3 place decimal) commonly corresponds to a +/-.005" tolerance, while a .XX (2 place decimal) commonly corresponds to a +/-.010"...
See more

Part and Inventory Search

Back
Top Bottom