dear carf
thank you for your reply.
its a good question
what pressure(temp) does these products take.
what brix can you take the pulp (minimum moisture desired)
what temp. will you cool to ?
what vicousity do you expect the product to have at that temp.
please give me your e-amil and i will send...
I have designed and patented a new type processor, which is used for processing (ie/heating/mixing/evaporating/cooling)especially high viscous liquids.
The system comprises,in its basic form , two cylinders, each with a piston driven independently by external hydraulic cylinder. The piston end...
dear sir
thank you for your interest in the scraped surface heat exchanger.
we consider 200°c so far to be the upper limit.
our pilot plant is designed for 35 bar pressure but we will go higher in production versions should it be neccessary.
the internal volume of the pilot unit is only 2 liters...
thank you for your interest in my heat exchanger concept.
the h/e is designed to handle food products but where the apv or alfalaval h/e tends to rotate the product with the scrapers my machine actually push the product from side to side as it flows through the vessel. this i belive will give...
i have developed and patented a dual surface scraped heat exchanger especially designed for high viscous liquids.
The flow annulus can be as little 4-5 mm wide and instead of turning the inner cylinder 360° it reciprocate 90° back and forth pushing the product in and out between the longitudinal...
paez
I have developed a dual surface scraped heat exchanger which will be tested at the technical university of denmark this sommer. from this we should know the caracteristics of the heat transfer of this special type. please look at www.deltapro.dk for more information.
i am looking for...
