I changed the material on a part that had previously ran fine. When I ran the analysis, 5 of the six fixtures defined resulted in a "fixture transfer failed" error right out of the box. Any help would be greatly appreciated.
I found the answer to my own problem. There is a file "fmesh*.*" in the simulation folder that Cosmos creates. Apparently this file occasionally becomes corrupted or something. I deleted the file and all my problems went away.
I have an assembly that until recently (yesterday) would mesh. Now it will not mesh at all. The specific error says that the surface mesh was successful but that the volume mesh failed. Even individual parts (which have not changed) will now not mesh. Things I have tried:
1. "update all...
