Yes, I think it's fine, but for my application I've already bought three thermocouples and I would like to use them...My temperature range is between 15°C and 40°C, therefore it is a common range.
I just would like to know what calibration procedure is more accurate or advised especially if I...
Dear btrueblood,
thank you. So you recommend using the electronic signal conditioner, don't you?
I don't unserstand why people sometimes use the other method, because in my view:
1) the calibration law is not linear
2) the signal is very low (of the order of mV) and so it may be affected by...
Dear all,
I just would like to ask you for some advice.
I have to do some temperature measurements with a thermocouple K type and then acquire the voltage output with a NI DAQ card.
I have got an analog conditioner which compensates the cold jucntion of the thermocouple, linearizes and...
