Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Emma Gibney

  1. Emma Gibney

    Position control box won't show up under threaded hole dimension

    Hi all, I'm having a problem creating a ME drawing using the creo gd&t control box. I would like the leader line to point from my hole's dimension to the hole with the gd&t box underneath, however the picture attached below shows what the program gives me. Thanks for any help, Emma
  2. Emma Gibney

    Shore A properties under compression

    Hello, I am looking at a 19mm thick 63mm diameter disk of shore A rubber. It is being used alternating with aluminum disks to simulate a cervical spine. I know the stiffness of the spine required and the modulus of elasticity of the aluminum but I need to find the required compression on the...

Part and Inventory Search