Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ERCPT

  1. ERCPT

    Washer as load bearing element (analysis)

    Thanks for the tip, Israel/Cory! This is a resource I'm not familiar with currently, but will look into. Rb, this setup is not the generally accepted use for a washer :). I'm just trying to get away with a cheap solution. Thanks all.
  2. ERCPT

    Washer as load bearing element (analysis)

    I'm having some difficulty approaching the stress analysis of a washer with a load applied uniformly over 360 degrees. The setup is a washer held against the end of a 24mm shaft via a standard machine cap screw. On the shaft is a cylindrical mass which sees a load (Mass OD > Washer OD, Mass ID...
See more

Part and Inventory Search

Back
Top Bottom