Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Espen Lund

  1. Espen Lund

    Parameter study of parts modelled by the top-down design approach

    Hi all, I want to do a parameter study in ansys of a part (call it Part A) modeled with Inventor 2016 using the skeletal modelling technique. This means its geometry with all parameter driven dimensions are found in a master part (Part B). Here is the problem. I am not able to import part A...
  2. Espen Lund

    Question about required load combinations from Table 5.5 in ASME VIII

    Thank you for your answers, all. But how do I then identify the correct load factor for the torque action? "D" does not exactly fit the description. Do I then simply add L to the local load criterion, such that it becomes 1.7(P+Ps+D+L), or how do I know that 1.7 is the correct/intended safety...
  3. Espen Lund

    Question about required load combinations from Table 5.5 in ASME VIII

    Hi, So, I am analyizing a drive shaft that is pressurized thru several bores, but also transfers a significant torque. In ASME VIII table 5.5, all the required load combinations are defined. Here, I define the pressure as P and the torque as L, because the torque is a result of relative...
See more

Part and Inventory Search

Back
Top Bottom