Recent content by fayed175

btw thank

thank you i willl to do it... but this is something new for me...can you show me example? Thank!

what do u mean by "mounted flywheel on the nose of the shaft"? i cannot get it....

do you know how to make my result smoother?? i mean no more spiky graph as shown before... what cause this spiky results actually??

Oppsss sory.... i use the cyclindrical Joint at the crankshaft as shown in my 2nd attachment... yes i already try it with gently accelerating. So the result(smoother) are shown in the...

where to put that adm code? Is it same when i write this function: DTOR*AKISPL(time,0,v_spline, 0) to the Motion? Then the result for the forces of 1 spherical Joint is shown in the...

what is the meaning of DTOR?

Hello, Sorry i`m new to ADAMS.... what is adm code?

yes i already applied a motion using AKISPL for my spline data. what do u mean by add motor to a revolute joint? FYI, i used cyclindrical joint at the crankschaft as u seen in 2nd attachment... the problem is: when i measured the angular velocity at motion, the values are so high compared to...

attachment for crankshaft.... http://files.engineering.com/getfile.aspx?folder=ec7c2e0b-0e81-4d62-82b3-dfb928564a14&file=Motion.jpg

Hallo, I really need your help here. I want to run my crankshaft using the spline data as in graph( the red line). So i use AKISPL function for the motion(highlight in turqoise) in 360 degree using the velocity data (spline). However, i did not get the good result for the forces at the...