Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Flatmate

  1. Flatmate

    Multiple Data Search

    if it is possible, I'd like to see if it can be done using a spreadsheet.
  2. Flatmate

    Multiple Data Search

    please find attached the spreadsheet... A12 = Variable value B12 = Input C12 = Input D12 = Input E12 = Input F12 = Output from table of valueshttp://files.engineering.com/getfile.aspx?folder=530cae00-4949-41b0-9866-2ba6c10a6a01&file=Postage_Calculator.xlsx
  3. Flatmate

    Multiple Data Search

    I have 5 (Five) data inputs... one is variable and is dependant on the input value (so looking for a range) three are columns and one is a row... complicated I know. I have looked at using Lookup, Index and Match. Any suggestions or examples?
  4. Flatmate

    Pipe Profile Inputing Co-ordinates

    multiple sets of 24, each taken at a different point down the length of the pipe... the way I have discovered so far is to generate the 24 points at one position in the pipe on a plane, copy the sketch onto 5 new planes representing the pipe length and created a surface-loft. This works, but...
  5. Flatmate

    Pipe Profile Inputing Co-ordinates

    Is there a way to generate a profile of a pipe using co-ordinates. I have the co-ordinates taken from 24 locations around the circumference of the pipe and over a set distance. Is there a way of inputing this data into SolidWorks to generate a 3D image of the pipe?
See more

Part and Inventory Search

Back
Top Bottom