I agree completely. I have decided that V20 is better for me.
Hole alignment is bad. Also the editablity of the the hole type stinks. I wanted to change a simple hole into a counterbore hole. I was out of luck.
With the limitations of ST, the need of retraining, and the fact that many...
I agree with donyoung. I had to delete the round. I tried adding diameter dimensions to the tangent edge of round (where the round meets the cylinder.) But could not change the diameter.
To me it seems like ST requires many 3D relationships to get the model to update in a predictable manner...
Thanks donyoung
I was picking both faces then trying to establish the local symmetry. You only have to pick one face and ST will find the other. It is too bad the relationship is not persistant.
Still plugging away. Thanks
I decided to play with ST over the holidays. I agree with many of the posts that this is a completely different way of working. Here are two areas I am struggling with. I have not had training yet. Does anyone have any ideas to help me.
1. Local Symmetry (See image attached) - It seems...
