Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by GClegg

  1. GClegg

    Drilling 0.8mm Brass

    Do you have the material hardness ? What do the chips come of like If you can advise i can make some suggestions for the correct type of drill If you have vibration or a poor set with the Dremel don`t use carbide
  2. GClegg

    End Mill Jamming in Aluminum during CNC milling Attempts

    Hi Dominic You have got an engraving machine with a low RPM motor If you consider 200 m/min for Ali the calculations show you should be running 26,600 RPM Switch to HSS 8% cobalt uncoated carbide is not required
See more

Part and Inventory Search

Back
Top Bottom