I am looking for a method to bleed off CO2 or Nitrogen gas from a pressurized tank in a method that will optimize the expansive cooling properties of the gas. I am planning on bleeding the gas off through a flat plate heat exchanger to cool a glycol solution in the second circuit of the...
I'm not so much looking for design tips on what draft angle to use as much as I am looking for information on how to detail the parts and draft angles that are already designed (in tandem with the moldmaker) at the drawing level.
I'm guessing based upon the responses I'm getting that there is...
Where can I get a primer on detailing injection molded parts with variable draft angles?
Is there an asme standard on detailing molded parts and draft angles?
I've recently joined a new engineering firm that has a lot of injection molded parts and needs some clarifying of the drawing...
Additionally, we recently installed a new DELL w/ 3.4ghz xeon, 1400 nVidia Quadro and 2gb ram and it is incurring these 'SolidWorks terminated due to an unhandled error/Call your rep' errors faster than our slower machines. ONLY when it gets into and interacts with the vault.
Jason
The Server is Windows2000 Server and in terms of using perfmon to isolate the issue with the server, the problem with that is that the entire company uses this server, which means that it is nearly impossible to isolate and track our SW issues through to the server with a monitor located there...
First a specific question related, then a general one (long).
First, if we are running PDMWorks vault on the server with local license files, will this cause an issue, or is the issue only IF the network license is being used and non-local to the vault server?
Second, man oh man PDMWorks is...
