Hey, I know it's a silly thing to ask, but I kind of forgot such terms. Is the moment about the local x-axis (as shown in the figure), transversal or longitudinal moment?
Hello mates, so here's the issue. I have 2 towers connected together at a certain level with a bridge. I've done my analysis, and hinged connectivity between bridge and the floor slab was structurally the best.
My question: does the detailing presented in the attached image, by not providing...
Yes it's a 280 sq m residential floor slab. Never mind of the numbers in the jpg they're irrelevant in this matter... & yes there are 2 balconies: one at the bottom and one in the left.
I only did this since I was asked to take post tensioning as an alternative. It will be compared later on...
Hey there, attached is an image(preliminary one of course) of a post tensioned slab. Does it seem to have anything wrong concerning cable distribution (for example spacing between adjacent cables, etc...)?
p.s. cables in horizontal direction: 4 strands per cable / cables in vertical...
Thanks all for your valuable replies. Let me make it more clear. Referring to the attached image below, shall I develop the reinforcements till the end of the wall?!!http://files.engineering.com/getfile.aspx?folder=27e62c38-49e7-44df-b279-53f641e11346&file=Beam_Reinf.JPG
Hey, by what value shall we embed the beam rebars into exterior columns, so that pin condition is achieved?
I've previously heard that it's (0.1-->0.15 * effective depth), is this true?
Hi every one
i am doing a research about several techniques used to improve the bearing capacity of the soil
i found a lot of techniques used but what i didn't found the effect of using for example stone column on the bearing capacity of soil
can any body send me please a guide how we use this...
Hey there, are there any specific websites that list global and local costs of such material? The site I used to rely on seems to have shut down. Thanks in advance.
Hey there, are there any specific websites that list global and local costs of such material? The site I used to rely on seems to have shut down. Thanks in advance.
Hello everyone, here's my issue... I've modeled a 3D Frame, and when I press the calculation button, the program terminates; but one among 15 times it gave me: "Incorrect Data, Error Nr 5000". What might be the issue here?
@ johnbridge231 thanks for the reply, and yes I've tried Rigid connections and it slightly reduced the drift, still exceeding 0.02.
Here's the thread containing the analysis results if any help could be offered:
http://www.eng-tips.com/viewthread.cfm?qid=333719
