Good morning,
in this time I am working on piping class design after long time I done pure flexibility analysis. Design has to be done following the rules of B31.3. I started my career exactly doing piping class design so I know, but i don't remeber where is written, that ASME code requires to...
Good afternoon forum's designers,
I have a strange situation to deal and want discuss it with you. I have a small vessel, around 1m diameter and around 1.5m height, that treat exhaust gases. Like a big muffler.
Client want a design as for ASME VIII div.1 although pressure is less than 1 barg...
Dear Forum Colleagues,
I have some problem in understanding how ASME div. 1 treats welds and efficiency. Little bit of background: I have to design a simple small vessel with design pressure of 0.8 bar but without a dedicated program so I prepared my calculation by hand - following code - and...
Good evening dear specialists, I writing today because I have a question regarding yield criterions. A minimum of background: I have a simple filter, already evaluated by ASME VIII div. 2 par 5. The exercise is evaluate legs and attaching points with only weight + pressure.
I have ANSYS and...
