Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ismail BUHUR

  1. ismail BUHUR

    How can i change NPT Thread angle from 3º to 1.783º on NX.

    Ok i solved. Thank you Dave. Take Care.
  2. ismail BUHUR

    How can i change NPT Thread angle from 3º to 1.783º on NX.

    Dave, Thanks for your help. I am looking for I found "ugii_env.dat" file in UGII folder and opened it with notepad. But did not find. UGII_NOMINAL_DRAWING_THREAD_TAPER_ANGLE , in this file. 1. I will add this "UGII_NOMINAL_DRAWING_THREAD_TAPER_ANGLE=1.7833" in this file or i will find this...
  3. ismail BUHUR

    How can i change NPT Thread angle from 3º to 1.783º on NX.

    i am trying to draw 1/4 - 18 NPT thread. But when i measure NPT angle , i saw it 3º. It must be 1.783º (1º47'). How can i change this degree? Thanks in advance.
See more

Part and Inventory Search

Back
Top Bottom