Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jarquafelmu

  1. Jarquafelmu

    Spot Face dia, and depth.

    Thank you Ted, this helps alot. And thank you everyone for your answers.
  2. Jarquafelmu

    Spot Face dia, and depth.

    So then what might be an appropriate dia.?
  3. Jarquafelmu

    Spot Face dia, and depth.

    There is no specification on what the hole is used for. Or what the spot-face is used for. Just to find the proper depth and dia. to go with the hole dia. of 5/16" +/- .005".
  4. Jarquafelmu

    Spot Face dia, and depth.

    Hey guys. I had a question about a spot-face that I need to put on a part in NX5. The diameter of the hole is 5/16". Its on a flat surface. I can't find any mention of it in my drafting book and all I can find online is definitions what what a spot-face is and not how to determine the correct...
See more

Part and Inventory Search

Back
Top Bottom