I was curious what frequency IRstuff and electricpete calcuated for the second incident, at t= 6.783 minutes, into the 4th, 30 minute sweep which begins at 500Hz and A= 5 g's and descends to 5 Hz and A=.23g as shown in the attached 810F figure 514C-5C test sweep profile (each sweep is a mirror...
THANKS FOR YOUR RESPONSE btrueblood!
PLEASE ANSWER MY QUESTIONS BELOW [BRACKETED]:
freq = (5 Hz) * 2^(t/.2215) for 0<t<t1
[I ASSUME THAT THIS IS "eqtn 1" you are referring to below?
CAN YOU TYPE OUT THIS EQUATION OR DIRECT ME TO A WEB SOURCE WHERE I CAN SEE THE DERIVATION OF THIS EQUATION...
THANKS FOR YOUR RESPONSE
[ANSWER TO YOUR QUESTION AND MY COMMENTS ARE BRACKETED]
Your information seems to still be incomplete.
Is each sweep immediately after the previous? [YES]
i.e., does 00:37:53 represent 7:53 into the second sweep?
[YES]
If so, then the frequency should be
5 Hz *...
We recently subjected one of our devices to a sinusoidal vibration test (per MIL STD 810F, method 514C-18) at a local test house that used a sweep-rate of 0.2215 octaves per minute. The 810F test is performed in 3 axes, consisting of six (6), 30 minute sweeps per axis, ranging from 5 Hz to 500...
I need a to locate a spray or coating that can be used on both GE Lexan 943A-116 [use: Inj-molded plastic cover that features an LCD viewing window for an industrial control] & GE HP92W 7mm thick film [use: top {external} material layer of domed membrane keypad]. The product is intended for use...
