Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Jeevan24

  1. Jeevan24

    ANSYS Workbench 15 Error (An internal solution magnitude limit was exceeded)

    I have experienced similar issue before. One issue could be one or more of the cable is interfering with other cable. Run part detection to see if there is any interference. Another way to is to turn on Newton-Raphson Residuals (NRR) and identify the location. There could be more than one...
  2. Jeevan24

    Material properties required to run FEA analysis on Laminated veneer lumber (LVL) in ANSYS

    I am working on project to study FEA vs experimental data correctional. Plotting deflection vs load curve data to understand the trend. I am looking for ASTM standards to calculate Orthotropic Elasticity of Young’s Modulus, Poisson’s Ratio and Shear Modulus as input value in ANSYS. Could you...
  3. Jeevan24

    Memory requirement for +10 million elements

    Current model has 10 millions element. hardware spec is 3.07 GHz, 4 core, 12 GB RAM. Using 4 core to run analysis. How much more memory do I need to be able to run min. of 10 million elements. Thank you very much for your help. Jeevan
  4. Jeevan24

    Please use the enorm command to correct it

    Hi Sid, Thanks for the response. I was able to fix the problem by suppressing the multiZone meshing method in the mesh tree. I will try using the SURFACE FLIP with the multiZone unsuppressed in the future. Thanks Jeevan
  5. Jeevan24

    Please use the enorm command to correct it

    How do I implement this command into workbench to solve the meshing issue. Appreciate your help. Thanks
See more

Part and Inventory Search

Back
Top Bottom