In NX9 there were 2 commands flange & form/unfrom but when I load my .mtx from NX9 to NX11 those two commands are somewhere else. Has anyone found these in NX11.http://files.engineering.com/getfile.aspx?folder=b4bc9da0-2d85-49fc-bb3c-1347ce513111&file=nx9_1.JPG
attached is the assembly file naming for the drafting sheets...http://files.engineering.com/getfile.aspx?folder=8ddd1ed6-6e70-4a5a-8ea3-7112d780cc46&file=assembly_naming.JPG
I have the assembly file open maaxxxxxs.f01.0019.prt (native nx) see attached pic for naming of the sheets in the assembly file. There are components loaded in the assembly file (details that make up the complete assembly) and they have drafting sheets. yes the file naming convention would start...
I am looking for a way to export the entire assembly with all the details loaded in the assembly with the drafting sheets from the layout & details into a single .pdf file that will have all drafting sheet from layout and details on a .pdf file.
On nx...
