But then the question would arise that if tower is such ruggedly built why it displaces like 3 meters or so. I mean if based on structural engineering, this is very very huge. I know that when I tell someone this they always say its not possible and i also believe it so. Also the ooperator told...
Hi,
Thank you all for your nice commemts. Bit Gr8blu, I have asked the operator that what kind of deflection they usually get, i got the answer that its about something less than a meter even when the full load is on.
Also I want to test my model for very extreme situation, which will cause...
My structural model is that there is the tower which has diameter of about 6.5 m at base and 3.5 meters at top. Thickness about 45 mm at bottom and 18 mm at top
Yes, its tapering as well.
The deflection calculation i did theough fem and simplified by hand. Both match reasonably. So I am sure if...
Yes,
I understand this. I have the fem model which I built from an already exisiting wind turbine. The fem model has the tower but not the blades. The model works fine for modes of vibration, etc but just this deflection is a problem. 800 kN also sounds reasonable but thats what i dont...
Hi,
I have a mast that is 150 meters, the diameter of rotor is 162 m, the thrust coefficient is 0.635 and wind speed is 10 m/sec.
Now, by the equation
T= 1/2* density of wind*area of rotor*thrust coeffcient* speed of wind^2.
So I get around 800 by this. Applying such huge force obviously...
HI,
I am doing a project where i need to provide to do the structural anlysis of a wind turbine tower. For this purpose, I calculated the thrust force using the actuator disk theory. The problem with this is it provides me a huge point load of 800 kN. and when i apply this load on the tower it...
Hi,
I was working on preloaded flange connections of wind turbine towers, trying to model them in abaqus. I need the axial and the shear stiffnesses of the joint. For the shear its the Huths formula that I am thinking of using. But I dont understand what is the effect of number of bolts on this...
Hi,
I am trying to simulate the Preloaded flange bolted connection similar to the one in wind turbine towers. I am using the cohesive behavior to model the surface to surface contact where I need to provide knn, kss and ktt for the cohesive behavior.
I have tried reading the abaqus manual for...
The modes of frequency that I get from using cartesian and springs are almost same. First three as rigid body and afterwards some values which dont seem right.https://files.engineering.com/getfile.aspx?folder=79d232c0-d61c-42b0-8976-50913502230c&file=IMG_5176.jpeg
This is what the whole model looks like. I think the fix boundary condition cannot be actually removed as this is considered that the foundation provides a complete restraint to all degrees of...
