Recent content by kcantlon

I need to know the best way to dimension the depth of a cutout or slot. I have square tubing with a slot cut thru all and I am not sure where the best place to add the depth.

Not really, I am looking for how to define face knurling on a print and it must be different than a typical knurling callout.

I need help defining a face knurl on a drawing. There doesn't seem to be much information on how to convay this information to the machinist. In a standard knurl callout the TPI is needed and a diameter after knurling. On end face knurling what diameter is relative to the TPI? I am just guessing...