Recent content by Khalid Hameed

Thanks for sharing !

Alright @Si-bo . Thanks for highlighting my mistake.

I understand my mistake , thanks for your reply.

P= PD/2(SEW+PY) , pipe thickness calculation a/c to ASME B 31.3 , S = allowable stress value for the pipe material (and) P=PD/2000SFET , pipe thickness calculation a/c to ASME B 31.8 , S = Specified minimum yield strength of the gas pipeline what is the difference between S values , used...

Refer ASME BPVC SEC II Part D, Subpart 1 Stress Tables , TABLE 1A (Max. Allowable Stress Values for ferrous materials) & Table 2A (Design Stress Intensities). I want to know the difference in results we obtained by using each of them and what is their actual difference from theoretical point of...

I want to inquire about the operaional benefits we get by using solid wall/mono reactor vessel. apart from design.

Thank you once again for the amazing responses.

Thank you very much for your responses. Actually I am a novice and have just started to make a software as a part of my training for based on ASME. I was thinking how is the additional loadings defined in UG-22 are incorporated in the thickness calculated in UG-27 and what exactly the below...

how we can incorporate loading into the desired thickness of shell while designing pressure vessel?