Recent content by LayKanae

Hi Everyone! I'm using the NX 10 command "Model Compare" to review the changes that might have one of our parts ... I wonder if there is way of knowing the approximate value of the differences between one face and another, because when I generate the report it indicates the faces with numbers...

Of course! jajaj Thanks ;)

Hello John Baker And I asked directions for upload to GTAC, thanks for the tip !!

Sounds very possible I will review my Graphics card and drivers. Thanks Tomas!!

with this command you can set up operations and use Boolean for comparison You can see this command with Ctrl + E You can use expreesiones to sketch, wipes, patterns and more.

I do not know if I understand your question, but Have you tried using expressions? [ponder]

Hello everyone! I wonder if any of you have presented this problem in NX 9 or 10 [ponder] I tried installing updates or newer versions , but still see the same error in my assemblies. Someone who has an idea why is it? [sad] Thanks and greetings to all...

Hello Guys Does anyone has used or created a postprocesor for turning with TNC control in NX ? is it posible? I have not found any examples in postbuilder an i have problems starting from zero in this post. Do you know where can i find an example to start from of this post? Thanks

Hello everyone Someone knows if is posible adding the retract move for the "tapping operation" in NX, i want to cut .200 inches, and retract .100, just like a break chip operation. Thanks

Hello everyone I´m trying to create a slot starting with the operation "hole milling" in NX 8.5 I´m using a deckel maho dmu60 five axis. Since the slot is in a cylindrical face, i need to rotate the table and normally for this kind of operation we use plane spatial, but when generate the codes...

Hello Phoenx We designed a template per sheet because the title block was not kept in position when resizing ... In addition, block size title must change according to the size of sheet

Hello Jerry1423 No, we do not use Teamcenter

Faster and easier ways of doing custom templates So far I have applied different methods which are usually long and impractical, besides having to make templates for each sheet type, because I when resize the sheet... the formatting is lost I've seen some friends perform the same templates...

Hello everyone! I guess the majority already have some knowledge about the launch of NX10! I'm excited because I saw that this new version has some improvements in 2D, However... Does anyone know if it has improved the creation of drawing templates?

Thank you !! The NX works perfectly !![bigsmile]