Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Luke Barber

  1. Luke Barber

    Quality of WEG motors?

    Thank you for the suggestions. I found the following post by a Baldor engineer helpful. https://precisionautomation.net/2019/04/08/operating-motors-in-wet-or-damp-environments/
  2. Luke Barber

    Quality of WEG motors?

    Just had a brand new 10 hp WEG motor erupt in flames at a car wash. No kidding, it looked like one of those dragsters. This is the third one in a short period of time that's done this. The other two lasted a little longer in time, but were not used much before they failed. Little too odd, just...
  3. Luke Barber

    Buck Boost Transformer 380V 240V 3Phase

    I have a machine that I built for the US. It has a couple of Lenze servomotors https://files.clrwtr.com/userfiles/ct/documents/lenze/lenze-mcs-synchronous-servo-motors.pdf and Lenze VFD 240V three phase. https://files.clrwtr.com/userfiles/ct/documents/lenze/lenze-smvector-washdown-duty.pdf I...
  4. Luke Barber

    Transformer help

    Hello guys, I have 2006 CNC 3 axis Bridgeport/Harndinge EZ Vision Mill My machine is wired for 3 phase 460 volts 2.0 KW 3.3 amps and 1.1 Spindle amps My question, I only have single phase 240 coming in the shop. I also have a used Hitachi VFD...

Part and Inventory Search