Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by MadEngineMech

  1. MadEngineMech

    3D hole parameters on 2D design table

    Hey folks! I need to extract some information from 3D holes in order to create a drawing design table. So, here is the point: I need a table with these parameters: "Diameter", "X", "Y" and "Z". The command "Hole dimension table" gives the "Diameter", "X" and "Z". It does not return the "Y"...
See more

Part and Inventory Search

Back
Top Bottom