Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by magyver

  1. magyver

    Spaceball FLX 4000 and NX9

    One thing I have found that isn't really an issue. Is actually you don't need to open your parts through the file explorer, but when you start NX, when it's open tap the spaceball then you can open files normally. Rob
  2. magyver

    Manipulating Parts List Generation of Callout detail #'s in NX9

    Is there any way that I can group certain items of my assembly to have the parts list assign callouts 1-100 for one sub-assembly, then have the next sub-assembly to start at 100-200, the next 200-300. Etc Rob
  3. magyver

    Spaceball FLX 4000 and NX9

    Hi Everyone, If you have an older spaceball FLX4000, the spaceware version 9.3.0 works great on NX9 on windows 7 and 10 platforms. I'm using a serial port adaptor. All is good, much cheaper than the cheapest Space Navigator.
  4. magyver

    Spaceball FLX 4000 and NX9

    I managed to get it working on Windows 7 64 bit. The only way it get it to work though, is to click the model or assembly from the file explorer. I believe it was the last spaceware driver before 3D Connexion took over. I will check the version I'm using. Bought the 4000 FLX new in box for $75...
  5. magyver

    Spaceball FLX 4000 and NX9

    How can I get my Spaceball FLX 4000 to work with NX9?

Part and Inventory Search