Sorry for the delay in reply
In answer to your questions plyfrm
1. No specification on the drawing so in its absence i applied ASME Y14.5-2009
2. Yes
3. for example: the diameter at on end could be +0.03 / -0.01 then at the other -0.03 / +0.01 resulting in 0.06 total between them.
I have...
Hi All
My company are manufacturing a 1800mm shaft for a company. There are 3 diameters on this shaft each with a separate Total Runout specified of 0.076mm
My question is this: If diameter A run out is 0.05 (positive direction on clock) and then diameter B run out is -0.03 (negative...
