Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by matt0627

  1. matt0627

    Wind Load on inside office structure in an airplane hanger

    Thanks to all, I have a pretty good idea of how to attach the problem with a little imput from the client & everybody who wrote. Matt
  2. matt0627

    Wind Load on inside office structure in an airplane hanger

    Looking for some help. I have a mezzanine structure that has an in-plant office structure on the top of the deck system, approximately 12'-6" to deck surface plus a 10'-0 office module wall. The stucture is inside an airplane hanger for the military. ASCE 7-05 calls for a wind speed of 130 mph...
  3. matt0627

    Calculating Plastic Section Modulus Again

    Thanks to all: I've checked other size channel and came up with lower numbers than the table in AISC so I figured I must be doing something wrong. I get the same results for two channels toe-to-toe for the Plastic Section Modulus as toadjones. Once again thanks to all:
  4. matt0627

    Calculating Plastic Section Modulus Again

    When this topic came up before the procedure was what I remembered but I have 2 channels welded together to form a box shape. I want to calculate the plastic section modulus for the combined section, both diections.I wanted to check what I remembered so I looked up a C3x4.1 channel and tried to...
See more

Part and Inventory Search

Back
Top Bottom