Recent content by MediumInch

Dear Seniors, I am planning to buy a buried pipe stress program. How to evaluate best buried pipe stress software(Caesar-2 vs autopipe vs caepipe). Thanks in advance MI

Sorry for the late reply. Thank you so much littleinch for sharing your knowledge. can I ask one more silly question how does 40 degree bend moves and relives compression load? Thanks in advance.

HI LEECUP, I AM CURIOUS DID YOU CROSS CHECK WITH YOUR HAND CALCULATION(ASME B31.1 Nonmandatory Appendix VII)WITH CAESAR 2 IS IT SAME. THANKS. MEDIUMINCH

Thanks you so much. I will start my reading from ASME B31.1

Thanks a lot BigInch for sharing your knowledge and time. Is there any reference study material or book I can go through in order advance my knowledge in buried piping stress analysis. Thank you once again for your time.

Thanks BigInch for your insight. But still I couldn't understand the concept behind it, If I bend my pipe by 90 degree it will have more stress than 45 degree because when my angle decrease it cause more compression and tension on the down and up of a pipe. Can you please explain me the...

Dear Seniors, Our consultant did an study on buried pipe bend analysis and found when you bend buried pipe with lower angle higher stress and higher angle lower stress. How is it possible if I bend my buried pipe by 90 degree lower stress but if bend my pipe by 45 degree I have higher stress...