Cutting 1/4 aluminum with 7.5 lens Feed 30/min power 4000 Frequency 6 duty 100 gas pressure 1.10 gas N2 nozzle gap .02 Focus -0.098 .Aluminum type 3003 .Cutting through but still have major burr on back side .If anyone can take a screen shot of there Alum conditions for 1/4 for an a...
I Always was shown to have toe down and heel up on the use on restraining dog clamps or any clap. I thought is was it was strange that they would put 1.5 inch square tubing over the threaded rod and then the restraint and then the washer and bolt. Cause when you go to tighten the bolt down once...
NO its an old cut off sheer with a massive flywheel . In the picture the center clamp is totally horizontal and not even touching the make shift die. I would have taken a pic of the other press but they didn't set it up yet. That one has welded holders.
Ornerynorsk .Here are some pics.You will see Clams are level . and other wrong things. Sry about pic fussiness.http://files.engineering.com/getfile.aspx?folder=67941dba-f941-415e-9d45-9fd00f7f9642&file=Photo0051[1].jpg
Thx for the feed back ornerynorsk. These are being used in 30 to 40 ton punch presses stamping 14g steel .I told them that wouldn't pass a grade 9 machine shop set up.And that those machine are a good accident ready to happen .Put in a work refusal and let ministry get involved .Needless to say...
Yes that what I mean is manually tightened screw C-clamps . I myself are not running the machines .They are also putting washers between the C-clamp and bed under the tightening bold. Pictures soon.
FABPRO: Sorry that was 10 MPa you can also use mild steel conditions. I run Mitsubishi 3015 EX-S series. SS conditions work but not good piercing time to long .But I still only use a 7.5 lens
