Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Michael1988

  1. Michael1988

    Ansys 13 Workbench Converge Error

    HI Thanks for the help. I have added most of your suggestions. As I normally import my geometry from Solid Edge I have never utilized symmetry or truncated the model. But currently I am reading into it. Also how do I change the mesh from triangular to rectangular? Other than that I have...
  2. Michael1988

    Ansys 13 Workbench Converge Error

    Yes just the spring force. I have to use the FEA part for my dissertation in order to compare the simulated results to the actual results to prove that FEA can be used. I actually have no choice as it was decided by my lecturer.
  3. Michael1988

    Ansys 13 Workbench Converge Error

    I am trying to Produce the results of the spring probe. That is my main goal, I had one of my lecturers try and help but he seemed to confuse me more. Typically the spring values should start off at zero then increase to around a value of -200n at the top of the slope and along it until it...
  4. Michael1988

    Ansys 13 Workbench Converge Error

    Hi Everyone I am currently having problems with my Ansys dissertation. I have a problem where I need to move a spring unit up a slope, then along the surface, then into a notch and back out. Every time I solve it I the error "The Solver engine was unable to converge on a solution for the...

Part and Inventory Search