Recent content by MrNut

Thanks for the info!

Thanks for the heads up :)

Again, thanks! I would like to learn these things, is there a book or some litterature you can recommend that cover some of the equations and such you have used?

Wow! Thank you so much, think this will put me in the correct direction! :)

Thanks for the info, the material is the same for the whole clamp.

Hi, it is for a school project. The cylinder is part of a framework structure of subsea equipment. Additional lashing points was needed to be added to the product during transportation, so this clamp was developed.

Hi, I should have mentioned that the cylinder is vertical, the clamp may only slide downwards if the clamping force is not high enough. The tensile force is without a safety factor around 12000N, worst case scenario would probably be to assume that this force acts straight downwards. Assuming...

Hello, I have some questions regarding clamping force. I have a two-piece cylindrical clamp which is to be clamped around a cylindrical part. It is a clamp installed on a product during transportation, where lashings go between the clamp and trailer. The coefficient of friction and surface area...