Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by New to this

  1. New to this

    GD&T for bolted flange of two rotating parts

    Thanks for the replies guys. I learned some things! I have read over your responses a couple times and it seems I was at least headed in the right direction.. It seems I could improve what I had above to be more appropriate and consider some of the tradeoffs Burunduk was mentioning. I spoke to...
  2. New to this

    GD&T for bolted flange of two rotating parts

    Update regarding the location of the bolt holes to ensure the two parts bolt together properly: I added datums and a positional tolerance to the bolt holes using the Floating Fastener Formula in addition to the standard drilled hole tolerances for M6 bolts. Please ignore the positional...
  3. New to this

    GD&T for bolted flange of two rotating parts

    Hi all, I'm designing a shaft that has two halves that connect via bolted flange. I want to ensure that they're concentric, so I added a centering lip on one half to locate via LT1 fit in the other half. I'm concerned about the alignment of these two parts, so I started to look to GD&T to...
See more

Part and Inventory Search

Back
Top Bottom